title    
9153 E. Duarte Road San Gabriel, CA 91775                  Phone 626.292.1617   Fax 626.286.7879

kit title
Billing Boats       Caldercraft       Caldercraft Historic Static Models        Deans Marine       Graupner       Dumas Boats       Harbor Models
Model Slipway
           Microglass       Midwest       Robbe
       Ready To Run Boats

cat title
What's New!/ Home Page        Accessories (Click Here For Extensive List)         Batteries        Books        Tools        Clothing/Gifts        
Sounds         Lighting         Radios        Propellers        Motors         Mr. Darby        Couplers, Shafts, Nozzles, Bow Thrusters
Power Distribution Panel        Speed Controls
        Steam Engine        Polymer Fittings        Smoke Generator        PT Boats
Terms of Sale (Min. Shipping Charge of $6.00)

Harbor Models




Phillip W.

The Philip W., acquired in 1981 by Wilmington Transportation Co., is a twin-screw, 95-foot tug with a beam of 34 feet. 3500 horsepower provides 39.4 tuns of bollard pull.

Our model is 1/32 scale with a length of 36 inches and beam of 13 inches. Displacement is 35 pounds.

Deluxe Kit HAR147D

Includes all subkits listed below.

Basic Kit HAR147

The hull and superstructure are fiberglass. This kit includes the hull, deck house, deck house roof, pilot house, pilot house roof, fiddley, mast and exhaust stack. The deckhouse is scribed with all door, porthole and other openings. The pilot house has the window frames molded in.

The polymer fitting set, described below, is included, as are a set of photographs and plans.

Polymer Fittings

The polymer fitting set, made by Quartermaster Scale Ship Fittings, contains the finest fittings seen anywhere. This set includes right and left pilot house doors, three different water-tight doors (right and left for two of them), three different louvered vents, access hatches for the deck, raised hatches, fire hoses, port holes and life rings.


Deck Hardware
HAR1010

This sub-kit is cast in bronze and includes the bull nose, bow bitt, main tow bitt, pipe bollard for the rear deck, and four quarter bitts.



Running Hardware
HAR1011

The running hardware kit includes two 3°" 4-blade brass propellers, two shafts with stuffing tubes and oilite bearings, two cast polymer shaft supports, and three cast polymer rudders with stainless steel shafts.

 

HAR147D $599.00

HAR147 $399.00

HAR1010 $110.00

HAR1011 $109.00

 

Copyright Harbor Models 2008