 |
NEW SOUND MODULES - ONLY FROM HARBOR MODELS
-True Digital Recordings
-Includes Crank Over, Idle, Rev Up and Down and Stop
-Slight Movement of Propulsion Stick Gives Cranking and Idle Sound But No Prop Movement
-Produces Three Auxillary Sounds Controlled by Verticle Movement of 4th Channel Stick
-Auxillary Sounds Will Not Cut Out Motor Sound
-Will Not Over Heat and Shut Down
-No Sound Loop Clicks
-Generates 10 Watts of Sound
-No Additional Amplifier required
-Two Separate Volume Controls for Motor and Auxillary Sounds
-Adjustable Motor Sound at Idle and Top End
-Simple Installation
-Uses 8 Ohm Speaker (Sold Speparatley - Recommended Speaker: FRS7S, Found Below)
-Proudly made in the USA
Specifications:
Dimensions: 3 x 2 x 7/8"
Weight: 3oz.
Amplifier Wattage: 10watt
Amplifier Impedance: 8ohm
Current Draw: 2amps
TELL US WHAT YOU THINK....
Your input in the further development of our sound modules is important to us. Please let us know your likes and dislikes for the two diesel engine sounds now on our site. Also, tell us what other sounds, such as a PT Boat, that you would like to have.
email us: sails@harbormodels.com |
Order Below
Modules are ready for shipping! |
Diesel Sound Module with Auxillary Sounds - Version 1
The auxiliary sounds are controlled seperately from the motor sound. They have been combined into one sound for demonstration purposes only.
Click Here For Preview |
|
Diesel Sound Module with Auxillary Sounds - Version 2
The auxiliary sounds are controlled seperately from the motor sound. They have been combined into one sound for demonstration purposes only.
Click Here For Preview |
|
NEW!
Hicks Engine Sound Module with Auxillary Sounds
The auxiliary sounds are controlled seperately from the motor sound. They have been combined into one sound for demonstration purposes only.
Click Here For Preview
The Hicks diesel marine engine was manufactured around the beginning of the twentieth century at the docks in San Francisco. These simple power plants were employed by the local fishermen to propel the small Monterey Clipper fishing boats during the heyday of the West Coast fishing boom.
The Clippers used scrap automobile hardware and no two looked or sounded the same. The motors were started by jumping on a big stick wedged in the flywheel or by a rope wrapped around the flywheel and given one or two good yanks. Our sound module uses the rope cranking sound. The idle rpms and full speed rpms do not vary much as there was plenty of torque but not much get up and go.
The horn and bell sounds are basic and simple, just as on the actual Clippers. Install our smoke generator and you’ll be ready to re-create the ambience of Cannery Row in the 1920s.
|
|
Rocker Switch
Control electronic systems with this easy to read green LED illuminated indicator rocker switch. SPST (On/Off) 12 volt DC, 20 AMP rating, snap mounts in 0.53 x 1" rectangular cut out. |
|
 |
FRS7S High Performance 8ohm Speaker
This speaker is only 2.5 inches in diameter but delivers amazing sound quality. With a frequency response of 120-20,000 Hz and 15 watts of power the FRS7S will be sure to impress all modelers. |
|
 |
RAM STEAM ENGINE SOUND
This sound device produces the realistic chuff & hiss sound of a steam engine synchronized to shaft speed. 2" speaker. 6 to 14.4V.
RAM48 |
|
 |
ROBBE LARGE DIESEL SOUND GENERATOR
This unit produces the sound of a multi-cylinder diesel engine & is synchronized to motor speed. Fully adjustable tone. 6 to 12V.
Speaker not included.
ROB8276
ROBBE FOGHORN
This sound device has adjustable pitch. 6 to 12V.
Speaker not included.
ROB8300 |
|
 |
GRAUPNER SPEAKER
4" diameter speaker for use with multi-sound module.
8ohm with Mylar speaker cone. Highly water resistant. |
|
 |
RAM GAS/DIESEL SOUND WITH HORN
Sound device produces either gas or diesel sound synchronized to motor speed. Horn tone is adjustable. 4" speaker.
6 to 14.4V. |
|
 |
Ram Boat Saver w/ Pump
This device senses water in the boat's bilge & activates a bright warning light while the pump removes it.
9 to 12V.
RAM Four-Way Multi Switch
Mounted on a single servo, this switch will control four different accessories on one voltage plus two more on another voltage. |
|
 |
RAM GAS/DIESEL SOUND WITH HORN
Same as RAM38, but with a 2" speaker. |
|
|
|
RAM FOGHORN
This digital sound device produces the classic deep dual tones.
4" speaker, 6 to 12V. |
RAM Machine gun
Digital sound with 2" speaker.
9-18V. |
|
RAM 16" Deck Gun
Provides the roar and echo of a large gun. Digital sound with 2" speaker, 9-18V. |
|
RAM Whooper
Attack alarm common to destroyers. Digital sound with 2" speaker, 9-18V. |
|
RAM Sub Sonar Ping
Digital sound with 2" speaker, 9-18V. |
|
RAM Sub Dive Alarm
Digital sound with 2" speaker, 9-18V. |
|
Air Horn
Digital sound with 2" speaker, 9-18V. |
|
RAM Big Ship Whistle
A very deep and distinctive sound. Digital sound with 2" speaker, 9-18V. |
|
RAM Riverboat Steam Whistle
Digital sound with 2" speaker, 9-18V. |
|
RAM Tug Boat Horn
Modern diesel tugboat airhorn sound. Digital sound with 2" speaker, 9-18V. |
|
|
RAM Siren |
|
