 |
Harbor
Models Brand 12 Volt Speed Control
Fully proportional in forward and reverse. Set up for water cooling, if
desired. Operates on 12 volts and up to 10 amps.
|
SC1210
$79.95
|
|
Harbor
Models Brand 6 Volt Speed Control
Fully proportional, in forward and reverse. Set up for water cooling, if
desired. Operates on 6 volts and up to 10 amps.
|
SC610
$49.95
|
 |
Rookie Controller
A speed controller specially designed for model boats, combining high maximum load capacity with ultra-compact dimensions.
The motor in a model boat is often controlled by a stick function with a throttle ratchet. However, the neutral setting of conventional controllers is often so closely defined that docking manoeuvres are difficult because the exact neutral point is difficult to locate.
We have solved this problem with the Rookie Navy mP controller by expanding its neutral point to a significant extent. The controller also features a non-linear control curve, which means that ultra-fine control of motor speed is possible around the neutral point.
These features, combined with high-resolution motor control and a pulse frequency optimised for typical model boat motors, result in outstanding manoeuvring capability for your model.
The controller is equipped with a generous heat-sink designed to cope with high load currents, even in the part-load range.
Full, high-resolution speed control in forward and reverse; no brake function in the neutral position, as this is a nuisance during precision docking manoeuvres.
The speed controller features an integral Rx filter which suppresses brief interference and "glitches", and this is a further great advantage for close-range manoeuvring.
The unit includes a high-power BEC circuit which is capable of supplying the necessary power to multiple servos and auxiliary function modules.
Specifications:
Operating voltage:5 - 10 NC with BEC or 6-12 V lead-acid battery
Lead-acid battery´25 AMP Capacity
Functions: Forward, stop, reverse
|
ROB8423 $119.00
|
 |
Heavy Duty Nautical Throttle
This Glitch free solid state 12 Volt Speed Control can easily handle 45 amps and 60 amp surges. Fully proportional in forward and reverse. Optical isolation, 4KHz chop rate and extension signal filtering give reliable performance. |
SC1245
$119.95
|
 |
VANTEC
SPEED CONTROLS
411P:
Rating: 12 amps continuous, 30 amps surge for 5 seconds at 12V.
Fully proportional forward and reverse electronic speed control.
1.8"
x 1.9" x .82".
713P:
Rating: 30 amps continuous, 85 amps surge for 5 seconds at 12V.
Fully proportional forward and reverse.
1.75"
x 1.75" x 1" |
VAN411P
$79.95
VAN713P
$159.95
|
 |
Electronize
Speed Control
This
microprocessor-based unit will take up to 24 volts with a 30 amp
continuous load rating. Smooth in forward or reverse. Adjustable
speed range to match throttle stick travel. 33/8" x 2"
x 7/8" |
FR30
$99.00
|
 |
Rudder and Motor Mixer Control Unit
Automatically control the relative speed of two motors on your boat to achieve extremely sharp turns. As the rudder stick on the radio transmitter is pushed to a greater degree, the motors will change speed to pull/push the boat. Extreme rudder movement will cause the inboard motor to reverse for a tight turn.Works in both forward and reverse.
This solid state, micro processor works with any radio system and speed controls.
Output connectors provided for the rudder servo and speed controls. Must have 2 speed controls to work.
Includes LED power on indicator lamp.
Case size: 1. x 1.26 .79"
|
AJK101
$69.00
|
