Split Rudder, 1/Pack

Product Description

This is referred to as a "split rudder" because of the dual sections. The smaller, top section gets embedded into the hull for a secure fit. Since these rudders can handle large amounts of pressure this section will ensure the rudder shaft doesn't spin loose in the shaft hole in the hull.

Designed for an open wheel set-up.

Rudder Dimensions:
Height: 5"
Width: 2-15/16"

Rudder Shaft Dimensions:
Height (just portion out of the top of the rudder): 3-3/8"
Post Diameter: 3/16"

Accessories

Dubble Rudder Arm, 3/16"

Cast metal rudder arm with set screw drilled and tapped. Set screw is included.

Takes 3/16" rudder shaft
Over length (from shaft insert to control rod end): 1-3/16" (30mm)
Width (looking at it as a "V"): 1-7/16" (37mm)
Diameter (at the shaft insert): 1/2" (12mm)
Control rod hole diameter: 1/16" (1.5mm)

$5.95

Single Rudder Arm, 3/16"

Cast metal rudder arm with set screw drilled and tapped. Set screw is included.

Takes 3/16" rudder shaft
Over length: 1-3/16" (30mm)
Diameter (at the shaft insert): 1/2" (12mm)
Control rod hole diameter: 1/16" (1.5mm)

$5.49