Reversible by swapping the leads to the motor.

Length: 2 9/16" (56mm)
Width: 2 5/8" (66mm)
Height: 1 3/4" (45mm)
Weight: .25oz
Flow: 1/3 gallon/min @ 12V
Operating voltage 6-12 V
Conector 6.3 mm Faston
Self-priming
Use 5/32" ID tubing found below

Bilge Pump with Sensor + Warning Light

"Help, my model is sinking!"
That's unlikely to happen again with this bilge pump.

This pump features a sensor that immediately drains your model when it comes into contact with water or moisture. At this moment, a bright warning light, which can be attached to the outside of the model, also turns on.

The pump can be submerged up to 40 mm below water and is connected to a 9 V battery or the model's battery pack.

Includes 8 inches of 5/32 ID tubing to connect the output of the pump, if you think you will need more click here: 5/32" Tubing". Make sure to choose 5/32" from the dropdown menu before adding to cart.

If you need an outlet for the tubing click here.

This device senses water in the boat's bilge and activates a bright warning light while the pump removes it.
9 to 12V.

BattleSwitch is a relay switch that you toggle via hobby radio control gear. You can activate applications with voltage levels as high as 240V without having to know anything about microcontroller logic levels or transistors because the relay offers full electrical isolation from your receiver electronics.

BattleSwitch plugs into a standard hobby radio control receiver as easily as a servo does. You connect the load that you want to toggle using BattleSwitch's wear resistant screw terminals. Depending on the channel you use, you will then be able to control the relay by moving your radio's control stick up or down, left or right, or with a switch on your transmitter.

BattleSwitch has a status LED on the bottom. The LED will light up when the relay switch is on, and vice versa. It will also tell you if your radio link is too weak by flashing repeatedly.

The relay is a single pole double throw switch. It has typical lifetime is 100,000 switching cycles, depending on how heavy a load you are using.

SPECIFICATIONS:
Maximum current: 10Amp @ 28 VDC
Dimensions: 1.25" X 1.25" X 0.9"
Twelve inch servo pigtail

Fits through the bottom or side of the hull/bulwarks. Aluminum fixture with retaining nut makes for a smooth finished look.
Accepts 1/8" Tubing
1/Pack

1/8" or 5/32" Inner Diameters, choose from the dropdown menu
Very strong yet flexible.
Grabs onto nipples and won't let go.
Either fits 1/8" to 1/4" nipples

Sold by the foot